Product Information
PRODUCT INFORMATION
 
 
VMA-F590GW
VMAR F5E TIGER II 60-91 ARF - WING - GREY
 
 



1 Part#: VMA-F590GW   20070325
00008482
2 Dimensions: Please See Note   20070325
00008483
The dimensions of the Wing include the mounting Saddle plus any Ailerons, Flaperons, Flaps or other control surfaces unless otherwise noted. The Aileron Quantity is the number of aileron segments. This is usually 2 with one aileron on the right wing panel plus one aileron on the left wing panel. The Aileron Length is expressed as the length per aileron segment. The Aileron Area is expressed as the total of the area of all aileron segments. Flaperons by design have the same specifications as ailerons. Flap dimensions are denoted in the same manner as ailerons. Flap Quantity is usually 2 (one on the left wing panel plus one on the right wing panel). Flap Length is the length of each flap segment and Flap Area is expressed as the total of the area of all flap segments.
3 Terminology: Please See Note   20070325
00008484
The term "effective" is used to desribe the size of an object which is tapered or irregularly shaped. The term "chord" describes the linear distance from the leading edge to the trailing edge through a wing or control surface. The terms "saddle" and "saddle area" describe that portion of a flying surface such as the center section of a wing or horizontal stabilizer where it intersects the fuselage.
6 Wing Location: Attached to sides of Fuselage   20070325
00008487
7 Wing Span Tip to Tip: 55.59 in. (1412 mm)   20070325
00008488
8 Wing Span (effective): 55.59 in. (1412 mm)   20070325
00008489
9 Wing Chord at Root: 16.38 in. (416 mm)   20070325
00008490
The Wing Chord at Root was measured without considering the wing fairings that extend forward from the leading edge in the vicinity of the wing root.
10 Wing Chord at outboard end of Aileron: 7.68 in. (195 mm)   20070325
00008491
11 Wing Chord (effective): 12.03 in. (306 mm)   20070325
00008492
12 Wing Area: 668.62 sq in. (4313.66 sq cm)   20070325
00008493
13 Wing Width of Saddle (Effective): 8.67 in. (220 mm)   20070325
00008494
The Wing Saddle has an "Hourglass" shape. The saddle is 231 mm wide at the forward and aft ends. The saddle narrows to 199 mm in width at the midway point.
14 Wing Length of Saddle: 16.54 in. (420 mm)   20070325
00008495
15 Wing Area of Saddle only: 143.44 sq in. (925.40 sq cm)   20070325
00008496
16 Wing Area without Saddle: 525.18 sq in. (3388.26 sq cm)   20070325
00008497
17 Wing Airfoil Shape: Symmetrical   20070325
00008498
19 Wing Dihedral at Center: 0 degrees   20070325
00008500
21 Wing Taper along Leading Edge: Yes   20070325
00008502
22 Wing Taper Along Trailing Edge: Yes   20070325
00008503
23 Wing Thickness Maximum: 2.24 in. (57 mm)   20070325
00008504
24 Wing Material: Balsa Wood & Light Plywood. Ribs, Formers and Sheeting are Laser Cut. Sticks, Stringers & Strips are Saw Cut.   20070325
00008505
25 Wing Construction Method: Built Up   20070325
00008506
26 Wing Construction Adhesive: PVA, Cyanoacrylate and Epoxy   20070325
00008507
27 Wing Sheeted Fully: Yes   20070325
00008508
32 Wing Plugs In to Fuselage: No. This is a "one piece" wing.   20070325
00008513
33 Wing Front attaches to Fuselage with: Wood dowel in leading edge of wing   20070325
00008514
34 Wing Back attaches to Fuselage with: 2 nylon bolts   20070325
00008515
35 Wing Requires Struts: No   20070325
00008516
48 Wing Ailerons Factory Installed: Yes   20070325
00008529
49 Wing Ailerons Quantity: 2   20070325
00008530
50 Wing Aileron Type: Semi-Strip (2)   20070325
00008531
51 Wing Aileron Length per Aileron (effective): 11.22 in. (285 mm)   20070325
00008532
52 Wing Aileron Chord (effective): 2.539 in. (65 mm)   20070325
00008533
Wing Aileron Chord tapers from 76 mm at the inboard end (closest to the fuselage) to 53 mm at the outboard end.
53 Wing Aileron Area: 56.99 sq in. (368 sq cm)   20070325
00008534
54 Wing Aileron Area relative to Wing Area: 8.52 %   20070325
00008535
55 Wing Aileron Area relative to Wing Area without wing saddle: 10.85 %   20070325
00008536
56 Wing Aileron Hinges per Aileron: 3   20070325
00008537
57 Wing Aileron Hinge Type: Flexible Live Low Gap   20070325
00008538
58 Wing Aileron Hinge Material: Proprietary Super Strong   20070325
00008539
59 Wing Aileron Hinge Adhesive: Cyanoacrylate   20070325
00008540
60 Wing Aileron Hinges Pinned: Yes   20070325
00008541
61 Wing Aileron Servo Required: Yes 2 Standard   20070325
00008542
62 Wing Aileron Servo Location: Bottom of Wing aligned approximately 30% outboard from inboard end of aileron   20070325
00008543
63 Wing Aileron Servo Rails: Yes in Servo Cavity   20070325
00008544
65 Wing Aileron Servo Wiring Tube: Yes   20070325
00008546
66 Wing Ailerons Flaperon Ready with Computer Radio: Yes   20070325
00008547
67 Wing Flaps Factory Installed: Yes   20070325
00008548
68 Wing Flaps Mandatory: No. Can be locked at neutral position   20070325
00008549
69 Wing Flaps Quantity: 2   20070325
00008550
70 Wing Flaps useable as Spoilers or Speed Brakes by deflecting upwards: Yes   20070426
00008551
71 Wing Flap Length per Flap (effective): 9.29 in. (236 mm)   20070325
00008552
72 Wing Flap Chord (effective): 3.130 in. (80 mm)   20070325
00008553
Wing Flap Chord tapers from 90 mm at the inboard end (closest to the fuselage) to 69 mm at the outboard end.
73 Wing Flaps Area: 58.16 sq in. (375 sq cm)   20070325
00008554
74 Wing Flap Area relative to Wing Area: 8.70 %   20070325
00008555
75 Wing Flap Area relative to Wing Area without wing saddle: 11.07 %   20070325
00008556
76 Wing Flap Hinges per Flap: 2   20070325
00008557
77 Wing Flap Hinge Type: Flexible Live Low Gap   20070325
00008558
78 Wing Flap Hinge Material: Proprietary Super Strong   20070325
00008559
79 Wing Flaps Hinge Adhesive: Cyanoacrylate   20070325
00008560
80 Wing Flap Hinges Pinned: Yes   20070325
00008561
81 Wing Flap Servo Required: Yes 2 Standard   20070325
00008562
82 Wing Flap Servo Location: Bottom of Wing aligned approximately with the inboard end of the flap   20070325
00008563
83 Wing Flap Servo Rails: Yes in Servo Cavity   20070325
00008564
85 Wing Flap Servo Wiring Tube: Yes   20070325
00008566
87 Wing Color Top Schema: Predominantly One Color   20070325
00008568
88 Wing Color Top Main: Gray   20070325
00008569
89 Wing Color Top Trim: Single Stars and Bars (Red, White and Blue) Left US MARINES text Right   20070325
00008570
90 Wing Color Top Lines: Gray   20070325
00008571
91 Wing Color Top Rivets: 3D Gray   20070325
00008572
92 Wing Color Top vs Bottom: Different   20070325
00008573
93 Wing Color Bottom Schema: Predominantly One Color   20070325
00008574
94 Wing Color Bottom Main: White   20070325
00008575
95 Wing Color Bottom Trim: Single Stars and Bars (Red, White and Blue) Right. US MARINES text Left   20070325
00008576
96 Wing Color Bottom Lines: Gray   20070325
00008577
97 Wing Color Bottom Rivets: 3D White   20070325
00008578
98 Wing Weight: 1.64 lbs (745 g). Please See Note   20070325
00008579
The weight of the Wing is as it was when it is removed from the shipping box. This weight does NOT include the weight associated with any adhesives, spar joiners or other weight associated with end user assembly.

20120828 04:09:58 PST. Subject to Change Without Notice.
Copyright Richmond RC Supply Ltd. VMA-F590GW_spec.htm