Product Information
PRODUCT INFORMATION
 
 
SPC-TM_SM25J
SPEC TEMPLATE MASTER - SPINNER METAL - SM25J
 
 



1 Part#: SPC-TM SM25J   20070127
00004607
6 Spinner Material: Metal   20070127
00004608
11 Spinner Mounting System: Please See Note   20070128
00004614
The spinner backing plate is slid over the crankshaft and placed into contact with the engine thrust washer. The propeller and prop washer are then fitted next and retained into place with the elongated prop nut supplied with the spinner. The prop nut is then cinched down tightly. The spinner cone is then fitted so that the edge of the open end of the cone fits and is constrained from radial movement by the groove that runs around the perimeter of the front face of the backing plate. The supplied hex head machine screw is then used to secure the cone.
14 Spinner Prop Nut Tightens via: Flats on Side of Nut   20070127
00004617
16 Spinner Prop Nut Threaded to accept Screw to attach Cone: Yes   20070127
00004619
19 Spinner Crankshaft Collett Supplied: Yes. 1 Brass   20070127
00004622

20100307 23:46:56 PST. Subject to Change Without Notice.
Copyright Richmond RC Supply Ltd. SPC-TM_SM25J_spec.htm